de-catt downpipe
05 April 2008, 08:24 PM
#1
Scooby Regular
Thread Starter
Join Date: May 2007
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
de-catt downpipe
i am goin 2 be fittin a downpipe 2 my 54 plate wrx and just wonderd if any1 else had done it themselves so i know exactly wat 2 do and wat i need any help would b great
05 April 2008, 10:43 PM
#2
Scooby Regular
iTrader: (1)
Join Date: May 2007
Location: Simtek powered RA
Posts: 415
Likes: 0
Received 0 Likes
on
0 Posts
Easy mate,
Intercooler off,
Turbo heat shields off, some 10mm bolts a bit fiddly, there's a few.
Remove the 5 nuts that fasten pipe to the turbo,
Remove oxygen sensor,
Remove 2 nut and bolts from rest of system,
Fit new pipe
I cut the lower section of my turbo heat shield as it wouldn't fit over
bell mouth downpipe.
Hope this helps
Intercooler off,
Turbo heat shields off, some 10mm bolts a bit fiddly, there's a few.
Remove the 5 nuts that fasten pipe to the turbo,
Remove oxygen sensor,
Remove 2 nut and bolts from rest of system,
Fit new pipe
I cut the lower section of my turbo heat shield as it wouldn't fit over
bell mouth downpipe.
Hope this helps
Thread
Thread Starter
Forum
Replies
Last Post