FMIC, Induction kit, and abs clashing!!
#1
Scooby Regular
Thread Starter
Join Date: Dec 2006
Location: Oxford- the shire
Posts: 1,281
Likes: 0
Received 0 Likes
on
0 Posts
FMIC, Induction kit, and abs clashing!!
Done a few searches, i have the dilemma of my pipe from the turbo to the fmic clashing with the abs and induction kit near the wing.
The only solution i can see is to reposition the induction kit into the inner wing (like aps caf) and hope there is room for it in there along with the fmic pipe.
This pic although not really specific of the problem does show it.
Any thoughts or experiences on this problem please
The only solution i can see is to reposition the induction kit into the inner wing (like aps caf) and hope there is room for it in there along with the fmic pipe.
This pic although not really specific of the problem does show it.
Any thoughts or experiences on this problem please
#2
Scooby Regular
Join Date: Nov 2007
Location: n.wales
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
if you look at most v1/v2 kits the induction filter/pipework is just lifted above the i/c pipework, so resting on top. although as said many times on here it would be better to move filter into colder denser air.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM