how do i clean the boost solenoid and what is a MAF
#2
Scooby Regular
iTrader: (1)
1) Disconnect the vacuum pipes (remembering which ones are which. You may also want to clean them through as they will be where any crud is coming from.)
2) Connect the green self test connectors under the dash.
3) Turn on ignition.
4) Your fan and various other things will start to operate and the solenoid should start clicking.
5) Spray some brake cleaner into the vacuum ports and allow to drain.
6) Turn off ignition.
7) Disconect self test leads.
8) Reconnect vacuum hoses.
What is a MAF
Mass flow sensor - Wikipedia, the free encyclopedia
Last edited by slipstream_uk; 01 December 2007 at 02:20 AM.
#3
1) Disconnect the vacuum pipes (remembering which ones are which. You may also want to clean them through as they will be where any crud is coming from.)
2) Connect the green self test connectors under the dash.
3) Turn on ignition.
4) Your fan and various other things will start to operate and the solenoid should start clicking.
5) Spray some brake cleaner into the vacuum ports and allow to drain.
6) Turn off ignition.
7) Disconect self test leads.
8) Reconnect vacuum hoses.
What is a MAF
Mass flow sensor - Wikipedia, the free encyclopedia
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM