howdy guys,

after fitting a k+n I/K to the scooby I need to make some sort of heat shield.

I made one up for one of my R5 Gt Turbos using the metal light celing tray you find in office building once...but a mate of a mate got it for me

What sort of material would you recommend? I appreciate thats its got to be able to be bent/shaped/cut.

And where to get it from?

cheers

 

buttt

 

Speak to guy on here called harvey (posting name is the same) or this may help (will need some modification)

http://img.photobucket.com/albums/v3...d20Diagram.jpg

 

thanks mate,

If i remember rightly , you made your own heat shield?

what metal did you use and where did you get it from?

cheers bud

 

yep i basically went to a local metal dealer (aluminium) offered them some cash and they cut a bit off for me (larger than i required just in case i made a mistake cost about £10)











These are the piccies Harvey was good enough to send to me

Since i'm re-doing my sheild just got to find a dealer of carbon fibre

 

myblackwrx,

as always mate thanks

 

My pleasure