Fried wiring loom
Thread Starter
Former Sponsor
iTrader: (234)
Joined: Jan 2003
Posts: 14,406
Likes: 0
From: Over 500ft/lbs of torque @ just 1.1bar
Fried wiring loom
I think I have found the cause of the electrical problems I have been having.
Wiring loom near headers is fried.
Best way to repair?
Anybody know if I can get a section of loom to replace? Any idea of cost?
Cheers,
Bob
Wiring loom near headers is fried.
Best way to repair?
Anybody know if I can get a section of loom to replace? Any idea of cost?
Cheers,
Bob
Thread Starter
Former Sponsor
iTrader: (234)
Joined: Jan 2003
Posts: 14,406
Likes: 0
From: Over 500ft/lbs of torque @ just 1.1bar
Cheers Graham.
Think I am just going to repair the existing one. Damage not too bad....about 4 wires melted and need a clean up and covering....1 needs a few inches replacing. Can do without removing it.
Bob
Think I am just going to repair the existing one. Damage not too bad....about 4 wires melted and need a clean up and covering....1 needs a few inches replacing. Can do without removing it.
Bob
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM