hiya people i have recently bought the new evc 6 boost control for my 2003 sti ppp ive followed the instructions to pin point and have gone over it time and time again to make sure its fitted corectly i ran the two wire from the unit to the ecu for throttle input and rpm signal i have left the standard boost solenoid electrically connected but removed the hoses from it as the evc has taken its place. now the car will only boost to 0.5 and the diagnostic light has come on. my friend plug it in to his laptop and the code was boost solenoid. he reset the ecu but it comes back on a few mins later any help will be much appreciated thanks