Been running the low boost (Setting A - 0.8 bar) option on the AVC-R, which Andy set up for about a week to cut back on the savage fuel consumption.

I switched back to high boost (Setting B - 1.45 bar) option and put my foot down. Waaay too slow. Checked the figures and where it normally had a series of stars, its now the same as option A - 0.8 bar 43% duty.

Gutted.

Has the unit chewed up Andy's map, or is there some way to get it back?

I never play around with it as I dont really understand how it all works, which is even more annoying.

 

it's not the map.. it is the boost settings on the AVC-R.. the map is in the ecu..

there was a problem with AVC-R's doing this a while ago but thought it was resolved as I haven't seen it happen for a while.

Best bet is to talk to Andy about the settings that were in the AVC-R.

Simon

 

Thanks Simon, I appreciate its not the map - bad choice of words

The unit is probably a couple of years old now, so may be one of the old ones still with that problem

Will get in touch with Andy.

 

okay cool..

Simon