Now I know I will get hung by some of you for doing this, but hey here goes..

Which pin-outs on the ECU do I fit my Fuel Cut Defender? I need:

Ign Live
Ground
Map Sensor in
Map Sensor out.

I have a pin-out diagram and need confirmation on which wires and their terminal numbers..

Cheers, Dan.

 

Do I cut and splice only one MAP wire?

So from MAP to FCD. Then from FCD to MAP ecu???

 

Surely someone can tell me..

Please!!!

 

Righto..

This is how wire the FCD set at number 10.



Remove Negitive lead from the battery and remove the kickplate from the passengers footwell.

Locate the Pressure Sensor wires on Connector B43, pins 3, 4, 21. Connect FCD live to 3, FCD Ground to pin 21.

The FCD sits in series between Pressure Sensor Signal and the ECU. Cut wire a few inches before pin 4 and connect the yellow FCD wire to the ECU side and connect the FCD white wire to the feed.