CV Boot fitting
#1
CV Boot fitting
97 UK Classic
I need to change the boots on front CV joints. I've already split one and replaced with a split and glued one, but this looks like its leaking and the other one is bound to go just after I get my suspension aligned.
Can this be done by removing CV joint rather than removing the drive shaft from the hub ?
Ta
I need to change the boots on front CV joints. I've already split one and replaced with a split and glued one, but this looks like its leaking and the other one is bound to go just after I get my suspension aligned.
Can this be done by removing CV joint rather than removing the drive shaft from the hub ?
Ta
#2
The best thing to do is buy a "stretchable" boot and fitting cone (or use a cut off ribena bottle). All you have to do then is undo the hub nut and drop the whole cv / shaft out, cut the old boot off and push the new one on.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM