Fitting new injectors
#1
Fitting new injectors
fitting some STI injectors to my 2001 wrx and was just wondering is it necesary to use new o-rings. also does anyone have any tips or advice for fitting them.
#2
Scooby Regular
Join Date: May 2006
Location: Under the bonnet...still!
Posts: 592
Likes: 0
Received 0 Likes
on
0 Posts
Should always use new o-rings & gaskets on whatever you rebuild. I think there easier to fit than on the classics as Ive just found out today.
#3
Former Sponsor
iTrader: (20)
Join Date: Oct 2006
Location: 8.95 @ 168mph. Zero to 1KM 194.1mph
Posts: 1,150
Likes: 0
Received 0 Likes
on
0 Posts
Inspect the o rings for nicks, or damage. If they are ok, they will be fine to re-use.
Make sure they are clean, and oiled, or greased, and make sure the holes they fit into are also clean.
Mark.
Make sure they are clean, and oiled, or greased, and make sure the holes they fit into are also clean.
Mark.
#5
Scooby Regular
I've just fitted a set and the best advice I can give is to replace the O-rings, and grease the new ones lightly before going in. I just plonked the old ones back in and had to fit 3 of the injectors all over again because they were leaking. You may well get away with the old O-rings but for a few quid you may as well replace them while they are out. I always get taught the same lesson when I play with my car, do the job properly or do it twice
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM