right fittin this atm i know where the wires go in side just not sure on rest think the 3 pot Boost Solenoid goes like this - COM on the new boost solenoid to the wastegate actuator and from the NO connection to the turbo outlet not sure where this one is but what happens to the other pipe from the old Solenoid ? do i block somethig else off and what do i do with the pressure sensor where should i mount it and what pipe goes on it ?

Cheers for any help

 

well fitted it the right way the pipe from induction i blocked off ,what i think is the map sensor pipe the map sensor next to standard Solenoid i think 2 wayed in to the pressure sensor think thats the right way if i wrong can some1 reply car ran ok home just need 2 set this thing up as i thing its over boostin now then very soon get my apexi fc fitted and mapped by simon at jolly green once i can sort out when i want it booked in

cheers for any replys (if any lol)

 

from what you have said it sounds to be plumbed in correctly.

set it on the OFF setting and check you get around 0.6bar..

then set the duty to 20 and boost to 0.7 etc and adjust from there carefully.

Simon

 

cheers simon once again top man will email u asap and book it in with u