do i require any other parts such as a "t" section and extra vacume tube as the kit does not supply them also what the best way to route the wire's from
the bulk head to the side pillar mount.any advise would be appreciated.
MY00 uk
thanks

 

I fitted one of these to my car.

You will need, a short piece of vacuum tube ~5cm, an adaptor that goes from the vacuum tube into a female thread ( i got one from Le Mans motorsport), plastic T joiner.

I Teed into a vacuum/boost tube near the drivers side suspension turret. You fit the adaptor to the boost pressure sensor -- then the short section of tube and T it into a sutable pipe.

The wires can be feed into the car thru a grommet near the clutch master cylinder. Took me ages to get the wires thru because the connector blocks are so big.

 

what about running the wires from the grommet up to gauge by the pillar mount?

 

That's no problem, feed them from the grommet across to the lower edge of the dash. Then up the side (there's a plastic cover to hide them under) to the A-pillar. Sorted.