Removing bugeye wrx bumper
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Jun 2005
Location: Surrounded by sheep, tidy.
Posts: 3,294
Likes: 0
Received 0 Likes
on
0 Posts
Removing bugeye wrx bumper
Does anyone know how to remove a standard front bumper from an MY01 wrx? If so, a list of steps to remove it would be appreciated....
Thanks.
Thanks.
#2
Scooby Regular
iTrader: (1)
Join Date: Apr 2005
Location: In the Flatlands of Lincolnshire
Posts: 2,892
Likes: 0
Received 0 Likes
on
0 Posts
If I remember correctly;
1. Open bonnet
2. remove grill there are the fittings at the top and 4 clips at the bottom of the grill that need pressing with a long screwdriver whilst looking with a torch and gently pulling at the grill.
3. Remove both headlights to allow access to clips on the inside of the wing
4. I think there are clips that hold the inner wing to the edge of the bumper too.
It could be worth looking on the APS website (via WRC silverstone) and looking through the instructions for a FMIC
1. Open bonnet
2. remove grill there are the fittings at the top and 4 clips at the bottom of the grill that need pressing with a long screwdriver whilst looking with a torch and gently pulling at the grill.
3. Remove both headlights to allow access to clips on the inside of the wing
4. I think there are clips that hold the inner wing to the edge of the bumper too.
It could be worth looking on the APS website (via WRC silverstone) and looking through the instructions for a FMIC
Thread
Thread Starter
Forum
Replies
Last Post
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
MH-Racing
Subaru Parts
18
18 October 2015 04:49 PM