trouble hiting boost target in 1st gear
#1
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Oct 2004
Location: grimsby
Posts: 3,416
Likes: 0
Received 0 Likes
on
0 Posts
trouble hiting boost target in 1st gear
as above it usually only holds 0.5 bar till about 5.5k then boosts 1 bar then oops redline.
my car has full decat and scooby ecu (1bar). i dont have problems geting target in any other gears but spool is pretty slow?
apart from this cars running well, no judders, misses, or hesitation its just not boosting right.
ive cleaned the boost solonoid also. could it or the turbo be worn?
stew
my car has full decat and scooby ecu (1bar). i dont have problems geting target in any other gears but spool is pretty slow?
apart from this cars running well, no judders, misses, or hesitation its just not boosting right.
ive cleaned the boost solonoid also. could it or the turbo be worn?
stew
#4
As Tony says I thought scoobies didn't reach full boost in 1st gear both because it isn't needed and the engine load is low.
Fitting an APEXI AVCR might achieve it through the "gear Judge" setting but I might be wrong...
Midlife.....
Fitting an APEXI AVCR might achieve it through the "gear Judge" setting but I might be wrong...
Midlife.....
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM