Car won't start
#1
Car won't start
Also posted in Drivetrain (by mistake).
Help,
My 93 WRX wouldn't start this PM.
It's turning over, the fuel pump is working but it won't fire.
I've joined the connectors under the dash but the CEL is flashing continuously (meaning no fault found?).
The exhaust overheat warning lamp is on tho' - what does this mean?
Is it something to do with the lambda sensor going faulty?
Answers or advice greatly received.
Spender
Help,
My 93 WRX wouldn't start this PM.
It's turning over, the fuel pump is working but it won't fire.
I've joined the connectors under the dash but the CEL is flashing continuously (meaning no fault found?).
The exhaust overheat warning lamp is on tho' - what does this mean?
Is it something to do with the lambda sensor going faulty?
Answers or advice greatly received.
Spender
#3
Car ran fine all day Monday until 100 yds from home where, on a slight incline it started to misfire and wouldn't pull up the hill.
Tried to do an ECU reset but it wouldn't run properly, still no error codes on CEL.
Today it wouldn't start so I changed the Coolant temp sensor but it still won't fire up.
I cleaned the crank and cam sensors on Sunday.
Any ideas?
Tried to do an ECU reset but it wouldn't run properly, still no error codes on CEL.
Today it wouldn't start so I changed the Coolant temp sensor but it still won't fire up.
I cleaned the crank and cam sensors on Sunday.
Any ideas?
#4
Scooby Regular
iTrader: (1)
Join Date: Apr 2006
Location: Near Cardiff, South Wales
Posts: 717
Likes: 0
Received 0 Likes
on
0 Posts
I had this problem with an Evo 4 i imported, obviously different car but the same symptons, and that turned out to be the cam sensor. Try and borrow a mates if possible and if that does not work try the crank sensor next.
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM