Notices
General Technical
Sponsored by:
Sponsored by: CARiD

Check engine???

Thread Tools
 
Search this Thread
 
Old Mar 31, 2006 | 02:54 PM
  #1  
tay05's Avatar
tay05
Thread Starter
Scooby Regular
 
Joined: Feb 2006
Posts: 283
Likes: 0
From: Truckin through Wales!
Default Check engine???

Was driving along a twisty B road today having some fun, when the car started limiting itself to 4.5 thousand revs and the check engine light came on. The car is running fine appart from limiting itself, was running a little low on fuel at the time, so i've filled it up now. Was hoping after restarting the engine this would clear the fault but it hasn't. Do i need to reset the ECU? (its a standard MY93 WRX ECU) and if so how do I do this, disconnect the battery for a certain length of time? What could this fault be? Low fuel pressure? There are no leaks of any kind.
Also speedo stopped working yesterday, not my week Stripped clocks out and the speedo cable isn't spinning. The cable isn't snapped either, as if u try to turn it there is resistance, obviously something wrong the gear box end. What could this be? Any ideas on either problem?, ur advice would be greatly appreciated
Reply
Old Mar 31, 2006 | 04:58 PM
  #2  
tay05's Avatar
tay05
Thread Starter
Scooby Regular
 
Joined: Feb 2006
Posts: 283
Likes: 0
From: Truckin through Wales!
Default

Any ideas guys?
Reply
Old Mar 31, 2006 | 05:59 PM
  #3  
GazJenno's Avatar
GazJenno
Scooby Regular
 
Joined: Jan 2006
Posts: 931
Likes: 0
From: North Wales
Default

If the speedo's not working then the car will go into LIMP HOME MODE.

0.5bar boost, limited to 4k rpm or summit

i had the same problem when i stripped my speedo down as i wanted to change the bulbs in the back, put it all back together then the speedo wouldnt work, had to use it tho so out i went and all ran fine untill i floored it and it realised the speed was disconnected then it limited me.

found out that the speed cable is short and fell out when i removed the binacle and i couldnt put the cable back in whilst the binacle was out as it didnt reach. so i put the binacle back in with out the cable attached then had to reach up and plug the cable in.

yours might have come off at the gearbox end though.
hope this helps,
GAZ
Reply
Old Mar 31, 2006 | 06:17 PM
  #4  
tay05's Avatar
tay05
Thread Starter
Scooby Regular
 
Joined: Feb 2006
Posts: 283
Likes: 0
From: Truckin through Wales!
Default

Cheers Gaz, sounds like the same prob as me.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
kenc
Wanted
6
Oct 2, 2015 09:12 PM
speedrick
Subaru Parts
0
Sep 26, 2015 02:58 PM
shorty87
Other Marques
0
Sep 25, 2015 08:52 PM




All times are GMT +1. The time now is 05:56 AM.