Hi I have a manual boost controller but want to put my boost solenoid back on and not sure which pipe goes on where. Its a 2 post solenoid, so does the port sticking striaght down out the bottom go to the intake manifold or the turbo actator. Also does anybody know what my car should boost at. The gauge reads about 1.2 breafly dropping to 1 bar. My car's a WRX import 276ps.

Thanks
Mark

 

Boost sounds about right.

For a 2 port there is a pipe from the compressor bleed nipple to the WG actuator.

This pipe has a restrictor in it at the compressor end followed by a T-piece, the tail of the T is connected to the top (side) port of the solenoid.

The bottom port of the solenoid goes to the inlet pipe.

HTH
Andrew...

 

Cheers