RPM and TPS Signal wires - NOS anti-lag
#1
RPM and TPS Signal wires - NOS anti-lag
I'm just in the process of fitting my MY98 WRX with a NOS anti-lag system that will be contolled by a throttle position sensor switch (electronic snoop type), an RPM switch (the same as the other) and then shut off by a pressure switch.
What I need to know are the following:
1) What wire is for the RPM signal. I would imagine its one from the crank sensor?
2) What voltage does the TPS output. Max to min would be good as the switch is adjustable. Also which wire?
Cheers for any help.
Wayne.
What I need to know are the following:
1) What wire is for the RPM signal. I would imagine its one from the crank sensor?
2) What voltage does the TPS output. Max to min would be good as the switch is adjustable. Also which wire?
Cheers for any help.
Wayne.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM