As above, can anyone provide help and/or pics for fitting an oil catch can to an early classic. Bit of a novice when it comes to impreza's. Done a search, no good.
Thanks.

 

bonz, there are two different places where oil vapour is present.
1/ crankcase breather this is located by turbo. black 90 degree pipe leaves engine and goes to inlet pipe. u need to re route this to your catch can and block inlet pipe off at this point.
2/ rocker covers these are located to the left and right of inlet manifold and join together under the inlet manifolt b4 going to inlet pipe.
suprised u cannot find an old thread there are plenty been done some show pics. as your in midlands if your close enough to me (solihull) u could have a look at mine
ken

 

Here ya go

http://bbs.scoobynet.co.uk/showthrea...light=breather

 

Cheers Ken, I am in Tamworth, so only half an hour away, i may have to take you up on the offer!
Read the thread and i may have worked it out. (note the lack of confidence!)

 

ok bonz u can get me on 07769685461
ken