Not sure if this has been asked before but, what BHP is my turbo rated to? And at what pressure will it blow up. I'm running roughly 1bar. Any help will be greatly appreciated.

 

Around 340ish bhp have seen 1.6bar with a good mapped ecu,I wouldnt have thought you'd blow the turbo probably the engine first ...Your main priorities are the fuelling/ign/map get these done with supporting mods and you should have no worries.....

 

i was wondering on the power capabilities too!! i am in the middle of saving for an apexi power fc for my 93wrx.

So far for the engine i have hybrid fmic from harvey, HKS induction, full decat afterburner vortex angled system, ngk pfr7b plugs, new coil packs, rebuilt engine, ACT organic race clutch, exedy 4.5kgs flywheel, lightweight GFB pulleys, GFB stealth fx fully adjustable valve, walbro fuel pump and re-con g/box. z4 ecu with scooby ecu to 15.5psi running 290/300bhp.

hoping to run 340 - 350 ish with 550cc injectors and apexi power fc. perhaps more if i get the headers sorted - who knows!?!?!

just curious of the stability of the td05 foir this power.

tim