How slippy is a slip joint meant to be?
31 July 2005, 07:51 PM
#1
How slippy is a slip joint meant to be?
Have acquired a s/hand link pipe for std exhaust headers, but the slip joint is loose enough to turn each piece by hand.
Does the gap get taken up with a bit of heat/ will wrapping & painting seal it/ anything else seal it or is it junk?
Nick
Does the gap get taken up with a bit of heat/ will wrapping & painting seal it/ anything else seal it or is it junk?
Nick
Thread
Thread Starter
Forum
Replies
Last Post
MH-Racing
Subaru Parts
18
18 October 2015 04:49 PM