Has anyone managed this with a stadard top mount intercooler. The problem is that the injectors have to go after the intercooler and before the throttle body. I've got a V2 STI with a V4 intercooler so there isn't any room between them. Any suggestions?

 

It can be fitted into the IC end can, in line with, and just before the exit. The ally is thick enough to thread. Just don't go too big with the drill.


Mark.

 

Belting idea. Have you done it? If so how much benefit is there?

 

I have used it for a while very effective when the map is set to accomodate it
When I was running a TMIC I had mine in the location where Mark has said but since moving on to an FMIC I relocated mine to the underside of the throttle body.

Cheers