hello just changed oil, found what i think is crank sensor, tried to pull cap off but all i did was pull rubber seal down, looks like the wires are sealed inside the unit, it has a ten mil bolt holding it in, so i removed the bolt but still cant remove it its turning slightly but wont pull out, just tried again are these things just supposed to pull strait out

 

arghhh this is a pain in the árse can i not just take coil packs off i think it would be easier

 

reply hello again oil changed and car is running, got new problem now, engine check light will not go off now any ideas

 

5 starts and it should go off.

 

its not my lucky day, just messing with battery and got bit of smoke now have no ignition lights been in fuse box and there is a black wire with two spade connectors which is burnt i think due to the white marks around it, where do i get another, never seen one before, what is it