Car Set Up
10 December 2004, 06:35 PM
#1
Scooby Newbie
Thread Starter
Join Date: Nov 2004
Location: Leicestershire
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Car Set Up
I have just purchased a STI 04 model. I am looking at fitting a front struct brace, what will this do to the handling of the car? Should I also fit the rear struct brace or does it not matter?
Furthermore I was going to have the geometry set up, where is the best place to have this work carried out? I am in the midlands and what advantages will i gain?
What about a set of drop links? What do these do anyway?
Furthermore I was going to have the geometry set up, where is the best place to have this work carried out? I am in the midlands and what advantages will i gain?
What about a set of drop links? What do these do anyway?
10 December 2004, 07:51 PM
#2
Twatful
Join Date: Apr 2003
Location: Grew up and don't drive Scoobs anymore!
Posts: 9,050
Likes: 0
Received 0 Likes
on
0 Posts
Original droplinks are plastic and can flex, alloy or solid drop links allow the ARB's to 'do more work'
Consider fitting front and rear drop links and whitline ARB's as well as prodrive springs.
For a geometry set up try http://www.tsl-motorsport.co.uk/susp....html#geometry
Consider fitting front and rear drop links and whitline ARB's as well as prodrive springs.
For a geometry set up try http://www.tsl-motorsport.co.uk/susp....html#geometry
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM