Any ideas where the best place is to buy 440cc injectors?
Im thinking of maybe even getting 550cc but will have to change or modify the fuel rail.
Is the above a bitch of a job or is it pretty straight forward when you have the bits?
Its on a my93 WRX JDM

Cheers

 

Roger Clark Motor Sport (01455828610) or Mike at Scoobymania (0115 9708555)

 

You will need adaptors for phase 1 fuel rails to fit 550 cc/min injectors into your motor.

As it happens, I have a set of 550's and a set of adaptors, if you decide to go that route. { Change of plan here! }

Mail / PM for price.

Neil

 

Forgot to say, I am told that you will need a remap to use 550's in the current motor, despite other mods already done.

Other wise the physical fitting job is more fidly than hard or a major job, just a couple of screws on each injector and a plastic electrical plug.
The uprated injectors usually are sorted to fit, or a small plastic lug may need to be cut off for proper fit, but with the adaptor kit all else is straight forward.

 

i have 440s for sale from an sti6 just need a £35 conversion kit from pavlo so they fit into phase1 engine

£120 to your door

 

Thanks for the offer mate but just managed to get hold of some cheapish

Thanks though
Dave