Blitz NurSpec
#1
Scooby Regular
Thread Starter
Join Date: May 2002
Location: South West
Posts: 1,461
Likes: 0
Received 0 Likes
on
0 Posts
Blitz NurSpec
Had a good luck at this pipe today and all I can say is I am very impressed with the quality of it
However I have a MY00 UKppp and would like to know whether I can expect any problems with this pipe. Firstly I notice that it has a 3inch diameter bore rather than a 2.5 ? Will this mean that it won't fit to a standard Prodrive centre section pipe ? and with it being angled exit (straight pipework) - will this cause any lack of torque lower down ?
Anyone got one of these fitted and care to answer - I have a 'Catte' D/Pipe too btw
However I have a MY00 UKppp and would like to know whether I can expect any problems with this pipe. Firstly I notice that it has a 3inch diameter bore rather than a 2.5 ? Will this mean that it won't fit to a standard Prodrive centre section pipe ? and with it being angled exit (straight pipework) - will this cause any lack of torque lower down ?
Anyone got one of these fitted and care to answer - I have a 'Catte' D/Pipe too btw
Thread
Thread Starter
Forum
Replies
Last Post
crazyspeedfreakz
Wanted
17
05 October 2015 07:19 PM