Looking to wire in my LambdaLink digital sometime tomorrow but need some advice !
Rather than just wire into the back of the stereo again whereabouts can I source the following wires (colours?), under the dash?

Switched 12V - to come on at the ACC key position

12V lighting source - switched with the headlights

Not sure about the signal wires either.....

One is "To the sensors output signal wire" - I assume this can run into the Lambda input on the ECU? If so....which one is that?

The other "Must be connected to the sensor via the sensor body or a signal wire ground wire if the sensor has one". No idea about that one! Do I run that one into the engine bay and down to the Lambda sensor somehow?

I've not heard or seen anything about these gauges since the group buy months ago - I take it some people on here have them? I really would appreciate some help/hints on installing this thing!

Ta

 

My lambalink is all wired to the ecu.
Signal, 12v power & earth- ecu casing bolt.
My car is a pre 96 model, What model is yours as the ecu pin outs vary from earlier models to later.

 

The car is a P1 and the gauge is the LambdaLink Digital multicoloured thingy - I assume it wires in the same as the old lambdalink only with a couple of extra wires for the backlightting etc.

 

Sorry Simon Ive only got the ecu pins out diagram for the pre 96 cars. Yours will be different to mine. Hopefully someone else will be more helpful.