Bars+ard wont Srart

Reply Subscribe

Thread Tools

Search this Thread

Dec 30, 2003 | 09:32 PM

bodystyling

Guest

Posts: n/a

Can anyone help or had the same problem. Went to start car yesterday mourning and ended up killing the battery. Today carged battery to full cranked it over and it just turns over butwill noy fire. Someone suggested it might be that ive depressed the accelerator and the Ecu cuts the engine. I have a Gems Ecu so I dontno weather this has the same problem. Two days without the scob And Im going fooking crazy.

Dec 30, 2003 | 10:33 PM

Danny Boy

Scooby Regular

iTrader: (2)

Joined: Dec 2002

Posts: 1,197

Likes: 1

From: All over the place, trying to stop putting the miles on!

My mates GT4 just had this prob, turned out to be the fuel pump not working due to electrical fault.
Turn the ignition on till the dash lights up and then listen for the fuel pump whine from the back of the car, it should run for a couple of seconds to pressurise the system. If it don't ure engine won't be gettin any fuel so no go!

Dan.

Dec 30, 2003 | 10:37 PM

bodystyling

Guest

Posts: n/a

No its not the fuel pump thats fine.Its almost like its got damp inside the engine.

Dec 31, 2003 | 12:03 AM

Dark Blue Mark

Scooby Regular

Joined: Apr 2002

Posts: 7,333

Likes: 0

From: Bournemouth - 5x Ex Impreza owner. 997 GT3 CS.

Not radio mast interference with the immobiliser? Loads of people have been caught out with this lately. Push it 50m down the road and try it.

MB

Dec 31, 2003 | 07:32 AM

drb5

Scooby Regular

iTrader: (4)

Joined: Jun 2003

Posts: 9,201

Likes: 0

From: Scotchland

spray WD40 on all electrical conections and make sure the battery is properly charged, then try it

Dec 31, 2003 | 07:56 AM

Gidney&Knowlesy

Scooby Regular

Joined: May 2003

Posts: 2,031

Likes: 0

Usually we would replace the standard ECU, if any sensors have gone down then it would show up almost immediately; though aftermarket ECU's usually take this facility away....

It will probably turn out to be something like a cam, crank or water temp sensor to be replaced.....

Dec 31, 2003 | 07:58 AM

bodystyling

Guest

Posts: n/a

Cheers for replies still fooked.

Trending Topics

MY99 Wagon-water in spare wheel well!

6

219
Little project i done V1 JDM STI TMIC using V1 inlet manifold

2

82
CV boot replacement.

18

697
Engine Number location

5

8.5k
Duplicate post ignore!

1

73

Dec 31, 2003 | 08:06 AM

bodystyling

Guest

Posts: n/a

Xtremescoobies We must of been writing our post at same time. Do you know how I can do a diagnostic to find out if one of the sensors are fooked. Ive had a problem with cold start since Gems was fitted but they have sorted this on a map which im getting done on the 24th. Its always taken a long time cranking it over but this time instead of firing after about 30secs it only fires maybe once or twice but not enough to start. Thanks foryour reply.

Tony