Drumstick removal
12 January 2003, 01:03 PM
#1
Scooby Regular
Thread Starter
Join Date: Aug 2002
Posts: 912
Likes: 0
Received 0 Likes
on
0 Posts
Eh?
any chance of plain english, you are getting this viewed, but no one is going to answer if we dont know what you are on about.
Do you mean the "track rod ends" on the ends of the steering rack assembly?
If yes, well undo the locknut first, then undo the locking nut to the suspension arm, and then either use correct "splitting tool" to remove the "track rod end", or give the hub a sharp whack with a hammer to loosen the taper seating.
[Edited by scoobyslut - 12/1/2003 1:06:25 PM]
any chance of plain english, you are getting this viewed, but no one is going to answer if we dont know what you are on about.
Do you mean the "track rod ends" on the ends of the steering rack assembly?
If yes, well undo the locknut first, then undo the locking nut to the suspension arm, and then either use correct "splitting tool" to remove the "track rod end", or give the hub a sharp whack with a hammer to loosen the taper seating.
[Edited by scoobyslut - 12/1/2003 1:06:25 PM]
01 December 2003, 01:48 PM
#3
Scooby Regular
iTrader: (1)
Join Date: May 2001
Location: Berk (s)
Posts: 2,491
Likes: 0
Received 0 Likes
on
0 Posts
The "drumstick" is a ball joint further in on the rack than the track rod end, it sits under the inner most rubber sleeve, I can't see how to remove the bast(ard) !
Cheers
D
Cheers
D
Thread
Thread Starter
Forum
Replies
Last Post