Got my STiV spoiler from DRM yesterday
Anyone got any fitting advice ?
I obviously need to drill extra fixing holes so some sort of template is required. Also the little foam circular bits that the screw go through where should they go. I assume they stick on the bootlid around the holes - or do they go elsewhere ?

Cheers

Gizmo

 

Gizmo,

I've put some answers in the General section where you posted the same question.

But, the pads go on the bottom of the spoiler where the threaded holes are, line up the spoiler on the bootlid, then lift off, leaving the pads on the bootlid to show where to drill the holes.

If you have any problems give me a call.

David

 

<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:<HR>Originally posted by DR Motorsport:
<B>Gizmo,

I've put some answers in the General section where you posted the same question.

But, the pads go on the bottom of the spoiler where the threaded holes are, line up the spoiler on the bootlid, then lift off, leaving the pads on the bootlid to show where to drill the holes.

If you have any problems give me a call.

David[/quote]


Thanks David

I've replied in general section post but got it sorted - too impatient to wait. Looks like I done it the long way round but same result.

Thanks to DRM for prompt service.