Break Calipers gone rusty !
#1
The Break Calipers on MY98 Terzo seem to have gone rusty especially the front ones.
I was wondering if anyone can recommend the best way to paint them and what sort of paint should be used.
Thanks.
[This message has been edited by rob barron (edited 20-04-99).]
I was wondering if anyone can recommend the best way to paint them and what sort of paint should be used.
Thanks.
[This message has been edited by rob barron (edited 20-04-99).]
#4
I have a suggestion. You can use 1200 degree engine paint. It is strong and can look really cool in the many colors it comes in. Be sure to take off the rust and then spray the calipers. (removed of course). Brakes can exceed 1200 degrees fairly easily, but I dont think the calipers themselves will exceed that. most heat transfer occurs at the disk and pads,so not to worry.
Thread
Thread Starter
Forum
Replies
Last Post
Phil3822
General Technical
0
30 September 2015 06:29 PM