Notices
General Technical
Sponsored by:
Sponsored by: CARiD

car holding back

Thread Tools
 
Search this Thread
 
Old Sep 22, 2003 | 08:44 PM
  #1  
the gus's Avatar
the gus
Thread Starter
Scooby Regular
 
Joined: Sep 2003
Posts: 45
Likes: 0
Question

can any body help i have a 1993 impreza wrx that keeps holding back.one minute it is fine then it is holding back a bit then it is as flat as a none turbo. so far i have fitted new plugs,new coils,fuel filter,air filter,d cat front pipe,new centre pipe,temp sensor under inlet manifold,lambda sensor,i have also changed the ecu,air flow meter,boost control valve,actuater. when ok its boosting at .8 bar,when raely bad .4 bar. dont what else to do any body got any ideas. also when boosting at.4 a blocked off the pipe to the actuater ,it should of over boosted but it stayed at .4

[Edited by the gus - 9/23/2003 6:55:30 PM]
Reply
Old Sep 22, 2003 | 10:40 PM
  #2  
ktomass's Avatar
ktomass
Scooby Regular
 
Joined: Sep 2003
Posts: 123
Likes: 0
Lightbulb

Look, here's another one like me, except I have Legacy turbo MY92!!Mine does the same and I really don't know what to do. I'm waiting for manual boost controller to see if that'll work.

Other then that I have't got a clue what it is, except when I reset the ECU (disconect the battery for 30 min) the car works perfect... at least for 5 km.

Reg,
Kristijan

Reply
Old Sep 22, 2003 | 11:04 PM
  #3  
mark@wrx's Avatar
mark@wrx
Scooby Regular
 
Joined: Sep 2002
Posts: 2,616
Likes: 0
From: Cumbrian Scoobs
Post

Try changing the knock sensor. It worked wonders on my 93 WRX. Not cheap though...
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Iqy7861
Engine Management and ECU Remapping
22
Oct 12, 2015 09:21 AM
ossett2k2
Engine Management and ECU Remapping
15
Sep 23, 2015 09:11 AM
ossett2k2
General Technical
9
Sep 13, 2015 09:35 AM
alcazar
Other Marques
9
Sep 9, 2015 05:42 PM
ossett2k2
ScoobyNet General
10
Sep 9, 2015 01:15 PM




All times are GMT +1. The time now is 07:34 AM.