Pin out for MAP SENSOR (Pressure sensor)
Thread Starter
Scooby Regular
Joined: Apr 2003
Posts: 1,541
Likes: 0
From: Cambridgeshire
I have a Map sensor from MY98> and would like to know the wiring pin out as I have an MY96 which has the same three pins but arranged differently. I know the three pins are +5vdc 0v(ground) and sensor output but would like to know which pins which on the newer sensor.
Cheers
[Edited by Delboy2 - 6/27/2003 7:45:06 PM]
Cheers
[Edited by Delboy2 - 6/27/2003 7:45:06 PM]
Thread Starter
Scooby Regular
Joined: Apr 2003
Posts: 1,541
Likes: 0
From: Cambridgeshire
Sure have 
. Needed the newer model sensor as the range on the older sensors saturate at 17.5psig(4.93v) and I want to run higher boost than this. The newer sensors max range is 24.2psig(4.73) which enables me to increase boost further. I am not using the standard boost control though
. Needed the newer model sensor as the range on the older sensors saturate at 17.5psig(4.93v) and I want to run higher boost than this. The newer sensors max range is 24.2psig(4.73) which enables me to increase boost further. I am not using the standard boost control though
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM
