Rear bumper gap
#1
On my STI Classic Series 2, there is a gap on the rear drivers side on wheel arch where rear bumper fits mates with the arch. This is not that large, but more than on the passenger side.
How does the rear bumper fix onto the wheel arch? is it bolted on? have not fully investigated, but perhaps I have lost a bolt from that side.
Any help, suggestions - much appreciated.
How does the rear bumper fix onto the wheel arch? is it bolted on? have not fully investigated, but perhaps I have lost a bolt from that side.
Any help, suggestions - much appreciated.
#2
I have not taken one off,only the front one,but I think it is a combination of being bolted to a steel frame and also plastic fasteners. Would not be surprised if you have lost a plastic fastener or two.
Les
Les
Thread
Thread Starter
Forum
Replies
Last Post
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM
Sub-Subaru
General Technical
1
28 September 2015 12:47 PM