Fitting a Dump Valve?
#1
Scooby Regular
Thread Starter
Join Date: Feb 2003
Location: Just outside Manchester
Posts: 415
Likes: 0
Received 0 Likes
on
0 Posts
Does anyone know how to fit a Forge Dump Valve? I have just purchased one and require help with fitting it.
Replies would be much appreciated.
Regards
Nick
Replies would be much appreciated.
Regards
Nick
#2
I presume from your alias that you are fitting this to an STi7.
You remove the old one and replace it with the new one...pretty straight forward really. You will find it bolted to the front of the intercooler.
If it is a recirculating type then its a straight swap, if its a vent to atmos. then you need to blank off the return pipe with the plug you get with the kit.
I had one on my MY99 but have not decided whether to fit to my STi7. I dont belive there to be any performance gain and the sound can get on your wick after a bit, also a bit too Max Powerish for a proper car like the STi ...but try it, you might like it.
[Edited by stratman - 2/25/2003 12:47:50 PM]
You remove the old one and replace it with the new one...pretty straight forward really. You will find it bolted to the front of the intercooler.
If it is a recirculating type then its a straight swap, if its a vent to atmos. then you need to blank off the return pipe with the plug you get with the kit.
I had one on my MY99 but have not decided whether to fit to my STi7. I dont belive there to be any performance gain and the sound can get on your wick after a bit, also a bit too Max Powerish for a proper car like the STi ...but try it, you might like it.
[Edited by stratman - 2/25/2003 12:47:50 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM