please help!

check engine came up showing code 45 (pressure sensor and solenoid)
changed the whole console but light still comes on!

it comes on occasionally but will go off after revving the car or boosting it. i have cleaned the pipes, checked the wires and checked that all the sensors are functioning.

any experiences with this. when the light is on, rev limited to 4500rpm where fuel cut/boost cut comes in but after that the light will usually go off where boost goes back to normal 1.1 bar.

any ideas to remedy this problem?

 

try an ecu reset?? disc battery for 10-15 mins.
My car started bringing up that fault the last time I put the engine back in. Resetting the ecu cleared it, and it hasnt showed up since

 

that usally means that the ecu has sensed a problem in the electrical side of the sensor no matter how much you clean it it aint gonna make it better you may have to buy a new sensor