Fitting oil pressure and temp senders
#1
I've just got some Autometer Oil Temp and Pressure gauges and was wondering where would be the best place to fit the senders??
The senders both have a 1/8 npt thread and come with various adapters.
For the temp one would it be better to have an adapter brazed into the sump or would I need a special sump bung?
and for the pressure do i replace the old sender or can i use the port above no3 piston??
Any help apprciated
Cheers
Mark
The senders both have a 1/8 npt thread and come with various adapters.
For the temp one would it be better to have an adapter brazed into the sump or would I need a special sump bung?
and for the pressure do i replace the old sender or can i use the port above no3 piston??
Any help apprciated
Cheers
Mark
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM