I'm looking to buy some new seals for phase 1.5 440cc side feed oe injectors to back into my V3 type r. On the ones I have taken out they have a top and bottom o ring and a middle section flat ring, which one is broken.

The kit from icp only shows the top and bottom rubber o rings? Do I need the other flat one?

Thanks,

Wayne.

 

There is only 2x injector seals on classics of any variation........might know a guy that can assist...

 

So, are we saying that only the top and bottom seals do anything? What's the flat washer and flat seal for? Do they seal?

I'm sure my phase 2 550cc with adapters have only the top and bottom o rings and they are possibly leaking passed the seals. I'm not sure if they should have any additional seals.

I have a set of 440cc phase 1.5 to stick back in that were tested by you. I'll call that helpful guy Alyn at AS to get some seals.

I'm probably going to find a nipped or damaged seal due to my ham-fistedness.

 

There is a flat more like nylon washer that sits on the flat recess in the injector rail. I'm sure that Stockcar fella will sort you out alright

 

Ph2 to ph1 adaptors and injectors use three seals to be correct.......