Notices
General Technical
Sponsored by:
Sponsored by: CARiD

hesitation off boost

Old Jan 9, 2017 | 03:44 PM
  #1  
burn's Avatar
burn
Thread Starter
Scooby Newbie
 
Joined: Jul 2006
Posts: 20
Likes: 0
From: Glasgow
Default hesitation off boost

Hi all, ongoing problems with my hawkeye. Cel came up with pre cat lambda duff, so changed it and initially the car ran smooth after a reset with ssm. Left for work this morning and the hesitation is back, although not as bad as before. It's more like a misfire at times, could this now be a coil on its way?

Any thoughts people? Starting to get disheartened with this car now.

Little background, 2006 wrx ppp wagon with 142k. Just had an ecu refresh, sas removal, new crank sensor and new pre cat lambda. Only code showing is p1410, as it's still plugged in as I believe there's some barometric sensor that's still needed?

Thanks in advance for any input.

Last edited by burn; Jan 9, 2017 at 11:40 PM.
Reply
Old Jan 9, 2017 | 04:08 PM
  #2  
Bazil_SW's Avatar
Bazil_SW
Scooby Regular
10 Year Member
Liked
Loved
iTrader: (4)
 
Joined: Aug 2015
Posts: 851
Likes: 17
From: West Midlands
Default

Chocked up maf sensor? It's pretty easy to take out and if its dirty, there is some good advice on the forums about cleaning it.
Reply
Old Jan 9, 2017 | 11:40 PM
  #3  
burn's Avatar
burn
Thread Starter
Scooby Newbie
 
Joined: Jul 2006
Posts: 20
Likes: 0
From: Glasgow
Default

I'll have a look at the maf and give the throttle body a clean, almost feels like someones tapping the throttle. On SSM, when it hesitates/surges the throttle body flap fluctuates a few percent.

What I did notice tonight is that if left a while to cool and then drive it again, it doesn't do it until the engines sticking the fans on, and then will carry on doing it intermittently. Noticed on SSM the temperature hovers around 91 degrees.

Thanks
Reply
Old Jan 10, 2017 | 09:34 AM
  #4  
JDM_Stig's Avatar
JDM_Stig
Scooby Regular
15 Year Member
Liked
Loved
iTrader: (3)
 
Joined: Feb 2009
Posts: 5,873
Likes: 44
From: Mount Weather
Default

If you think it may be Temp related have a look for a new CTS.
Reply
Old Jan 11, 2017 | 10:06 AM
  #5  
burn's Avatar
burn
Thread Starter
Scooby Newbie
 
Joined: Jul 2006
Posts: 20
Likes: 0
From: Glasgow
Default

I've got a thermostat to put in, so will try that as the car does seem hot, don't think the sensors wrong. If that doesn't fix the car running warm then I've got a blockage or head gaskets are failing.

Cleaned the maf and seemed a little better, still not right though. Feels like it's holding back, missing.
Reply
Old Jan 15, 2017 | 11:03 AM
  #6  
burn's Avatar
burn
Thread Starter
Scooby Newbie
 
Joined: Jul 2006
Posts: 20
Likes: 0
From: Glasgow
Default

Ok well I had chance to do some bits to the car yesterday, so I changed the thermostat, checked and regapped the plugs and gave the boost solenoid a clean out.

Thermostat has stopped the fans coming on all the time and it sits at the correct temperature. Win for that.

Plugs were gapped at standard 0.7 so just brought them down to 0.65, incase I've got a weak coil, or four.

And I just thought I'd blow out the boost controller.

Results are hesitation has pretty much gone, just the pedal is very sensitive, got to be very smooth with it. But I seem to have lost boost! Down to 0.8 bar. I'll start a new thread for that question.

Cheers for the input peeps.
Reply


Thread Tools
Search this Thread

All times are GMT +1. The time now is 08:04 PM.