Chrisp11981

iTrader: (1)

Hi,
Is the sc42 the same as a blouch 18gxtr? I.e. is it a roller bearing turbo?

Cheers,

Chris.

bustaMOVEs

iTrader: (31)

No, it's the 20GXT-R which is same as sc42. But the sc42 have a 7cm housing as the American versions direct from blouch seem to have only the 8cm or 10cm housing options.
Seems that scoobyclinic have either modded the housing for a smaller one or ordered them like that.

Chrisp11981

iTrader: (1)

Thanks for that,

Just ordered the blouch 18gtxr with 8cm housing, should be reasonable power (rated at 430bhp) but with good spool.

Chrisp11981

iTrader: (1)

Anyone have any experience of the 18gxtr with a 8cm exhaust housing?

Cheers,

Chris.

Dan_RA

SCR Turbos are made by blouch to our own tried and tested design

bustaMOVEs

iTrader: (31)

Should of used a 8cm housing for a wee bit more power

Dan_RA

power vs spool.... if you want power, gt30 or gt35 9 blade

bustaMOVEs

iTrader: (31)

Lol, I don't think that 1cm would affect spool that bad, and make it a 440 rated turbo.
Oh I know why, don't want it affecting the 46 sales

I see that 35 9 blade is pretty impressive regards to spool for a big blower

Dan_RA

the 35 9 blades are doing awesome stuff, near on 700bhp on 20% meth from a 2.1, and over on a 2.35 with race fuel.


sc46 now come with a 9 blade too if required, seen 476 from one on a hawk build we did on v power!!


to give you an idea how well the sc42 works, we sold 5 within a week, the demand is so high its untrue!!

S744hdv

iTrader: (1)

How do the sc gt30 and 35's compare against the gtx 11 blade turbos?

veerinder9

iTrader: (1)

The gtx 11 blade compressor wheel turbos are generally laggier but make more power up top and need more boost

bustaMOVEs

iTrader: (31)

I know lol, you had to physically put my name on one as there was only 2 left and site was down at time otherwise I'd of lost it

maps

iTrader: (3)

I've had an 18g built using an extended tip billet wheel with 5/5 blades, looking forward to seeing what it can do

Mark

stealthbomber

iTrader: (3)

Who did that out of interest, I've got an Andy forest 18g that I'd like to get billeted. Cheers.

maps

iTrader: (3)

Craig bellworthy built it, best look him up on Facebook and message him

Mark