Hi all,

I've been hunting down issues with my EJ20 Impreza Wagon WRX today, fixed an oil leak from the oil cooler o ring and I've just found two more leaks.

So, first and the most pressing issue is a coolant leak, which looks like it's coming from around the thermostat or above it?

12920304_1379329405425989_2530472061286442808_n by Tom Parker, on Flickr

12931274_1379328648759398_5158989241188923683_n by Tom Parker, on Flickr



I can't see a direct source, though it looks like it's been an issue for the previous owner (i've had it since saturday) and they've wound a jubilee clip round it in an attempt to stop it dripping. It hasn't worked and the coolant seems to be coming from above. I've looked topside of the block and can't see where it would be coming from.

Looks like a pig of a job whatever it is causing it.

Any ideas?

Second is an oil leak but I'll do a seperate thread for that.

Thanks in advance.
Tom

 

Could be the steel pipework running behind the cambelt cover & its various rubber connections under the inlet manifold, or the water pump seal tell tale hole.

 

Might just be the pic but looks like the pipe is split where you have left the old clip in the middle of that pipe?

 

I don't think it's the clip, it was on there from the PO, I only picked it up Saturday so it looks like it's had this problem for a little while.

From my research it's pointing toward the water pump gasket leaking so if the weather holds out tomorrow I'll be pulling the cambelt covers off and having a good look at whats going on. If I'm lucky I'll tighten the pump, but looks like it's going to be a new one if it's on its way or the gasket needs changing.

PO had the belt done but changed nothing else, no pump, no bearings, no pulleys. (great!) If it comes to it I'll change the lot. Needs a clutch in it too damnit!

 

Water pump.....had the same go on mine and after replacing it's solved the issue. Easy enough job to do yourself and a cam belt change while your there. I replaced my idlers too and good job ad they were ready to fall apart. But I'd go with water pump mate.

 

I think so too, going to pull the belt cover now and have a look!

 

[QUOTE=parker455;11818595]I think so too, going to pull the belt cover now and have a look![/QUOTI couldn't see much until the pump was out and even then the gasket looked OK. But was on v1/2 and hasn't been changed since manufacturer date. Needed doing and has stopped the leak

 

Ok so I pulled it all yesterday and it looks like it's coming from the thermostat housing, genuine subaru stat and gasket ordered to stop this. I'm still not convinced by the original hoses etc on there so I'm going to replace all the hose clamps while I'm at it.

Not thinking this will solve the problem entirely as I think it will likely be the waterpump aswell, but worth a shot before the belts off etc.