Notices
General Technical
Sponsored by:
Sponsored by: CARiD

Wrx sti 08 radius arm rubber

Thread Tools
 
Search this Thread
 
Old Oct 25, 2015 | 06:31 PM
  #1  
Lee225's Avatar
Lee225
Thread Starter
Scooby Regular
10 Year Member
iTrader: (1)
 
Joined: Jan 2013
Posts: 300
Likes: 1
From: Wilts
Default Wrx sti 08 radius arm rubber

Hello chaps
I bought myself a wrx sti 08 hatch back the other day and on the mot certificate there is an advisory, it says.
Offside front radius arm rubber bush deteriorated.
Does anyone know what bush this is and what are the symptoms of one that's gone bad?
I haven't had chance to get under car and look yet and was wondering if anyone had had this advisory on a car and could tell me which bush is required.
Thanks.
Reply
Old Oct 25, 2015 | 06:38 PM
  #2  
rob84's Avatar
rob84
Scooby Regular
15 Year Member
iTrader: (5)
 
Joined: Jun 2006
Posts: 5,287
Likes: 12
From: somewhere out there
Default

Originally Posted by Lee225
Hello chaps
I bought myself a wrx sti 08 hatch back the other day and on the mot certificate there is an advisory, it says.
Offside front radius arm rubber bush deteriorated.
Does anyone know what bush this is and what are the symptoms of one that's gone bad?
I haven't had chance to get under car and look yet and was wondering if anyone had had this advisory on a car and could tell me which bush is required.
Thanks.
Usually if you go under the front of the car With the car jacked up and the wheels hanging down you'll see the bush on the front transverse link aka arm rear bush split from the center mounting or perished badly.

Bush in question Highlighted in Blue
Name:  bush_zpsnxorxakz.jpg
Views: 0
Size:  102.4 KB

Part number 20204AG011
Reply
Old Oct 25, 2015 | 06:44 PM
  #3  
Lee225's Avatar
Lee225
Thread Starter
Scooby Regular
10 Year Member
iTrader: (1)
 
Joined: Jan 2013
Posts: 300
Likes: 1
From: Wilts
Default

Thanks for that. Do you know if it's a difficult job to do? And do powerflex sell these bushes?
Reply
Old Oct 25, 2015 | 07:02 PM
  #4  
rob84's Avatar
rob84
Scooby Regular
15 Year Member
iTrader: (5)
 
Joined: Jun 2006
Posts: 5,287
Likes: 12
From: somewhere out there
Default

Originally Posted by Lee225
Thanks for that. Do you know if it's a difficult job to do? And do powerflex sell these bushes?
I fit quite allot of these, Not difficult. I usually do them with the arm still on the car just unbolt it and swing it down on the ball joint. Run a thin air saw blade down the side of the bush case, Carefull not to damage the arm. Then tap it out with a pin punch and hammer. I then have a bush insert kit which in essence is a long threaded bar with two hollow cups on that the bush sits in and tighten the nuts on the threaded bar it pulls the bush in to the arm.

Powerflex do a bush but its a caster replacement kit for them
http://www.powerflex.co.uk/road-seri...Bush/1625.html
Reply
Old Oct 25, 2015 | 07:14 PM
  #5  
Lee225's Avatar
Lee225
Thread Starter
Scooby Regular
10 Year Member
iTrader: (1)
 
Joined: Jan 2013
Posts: 300
Likes: 1
From: Wilts
Default

Do you know what the symptoms are if these are worn out?
Reply
Old Oct 25, 2015 | 07:30 PM
  #6  
rob84's Avatar
rob84
Scooby Regular
15 Year Member
iTrader: (5)
 
Joined: Jun 2006
Posts: 5,287
Likes: 12
From: somewhere out there
Default

Originally Posted by Lee225
Do you know what the symptoms are if these are worn out?
I've never had one to the point to show anything major but...
Tyre wear is increased depending on how far its gone, less positive steering input as the bush flexes.
Reply
Old Oct 25, 2015 | 07:42 PM
  #7  
Lee225's Avatar
Lee225
Thread Starter
Scooby Regular
10 Year Member
iTrader: (1)
 
Joined: Jan 2013
Posts: 300
Likes: 1
From: Wilts
Default

Hopefully it'll be ok for a week or two until I get it done. One other question. Would you know what's the best engine oil for these cars? Mine has forged internals, it was done by scoobyclinic. Was going to give it a oil change but not sure which grade to use.
Reply

Trending Topics

Old Oct 25, 2015 | 08:18 PM
  #8  
rob84's Avatar
rob84
Scooby Regular
15 Year Member
iTrader: (5)
 
Joined: Jun 2006
Posts: 5,287
Likes: 12
From: somewhere out there
Default

Originally Posted by Lee225
Hopefully it'll be ok for a week or two until I get it done. One other question. Would you know what's the best engine oil for these cars? Mine has forged internals, it was done by scoobyclinic. Was going to give it a oil change but not sure which grade to use.
Mllers CFS 10w60 is my choice
Reply
Old Oct 25, 2015 | 08:23 PM
  #9  
Lee225's Avatar
Lee225
Thread Starter
Scooby Regular
10 Year Member
iTrader: (1)
 
Joined: Jan 2013
Posts: 300
Likes: 1
From: Wilts
Default

Thanks for your help. I shall order bushes and oil in the week and change them next weekend!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Harley87
Subaru
23
Dec 11, 2015 09:54 AM
Belly07
Subaru
2
Nov 12, 2015 03:46 PM
Beastie
ScoobyNet General
25
Oct 13, 2015 01:24 PM
RAGGY DOO
General Technical
6
Sep 18, 2015 09:18 PM




All times are GMT +1. The time now is 12:19 PM.