Supertech retainer and v5/V6 sti shims
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Nov 2000
Location: Norup, Denmark
Posts: 936
Likes: 0
Received 0 Likes
on
0 Posts
Supertech retainer and v5/V6 sti shims
Hi all
Have Any of you guy used that setup ?
I dont like that the retainer have a to Big cutout for the shim and it looks like it could Fall out as its a really low retainer compaired to the oe sti retainer
Is it needed to buy a complete set of shimless buckets to use the supertech retainer in this head ?
Thanks
Skassa
Have Any of you guy used that setup ?
I dont like that the retainer have a to Big cutout for the shim and it looks like it could Fall out as its a really low retainer compaired to the oe sti retainer
Is it needed to buy a complete set of shimless buckets to use the supertech retainer in this head ?
Thanks
Skassa
Last edited by Denmark; 05 June 2015 at 01:21 PM.
#5
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Nov 2000
Location: Norup, Denmark
Posts: 936
Likes: 0
Received 0 Likes
on
0 Posts
Thanks
I have had the valves cut to get the right valve clearance and have just measured a bucket and a shim together
I Cant seem to find the partnumber for another top retainer that would work
They are all in the 5.00-5.10mm range so looks like a normal range for the buckets from a newagde
Shimless would also be best as this engine is going to see some antilag/launch control
Thanks
I have had the valves cut to get the right valve clearance and have just measured a bucket and a shim together
I Cant seem to find the partnumber for another top retainer that would work
They are all in the 5.00-5.10mm range so looks like a normal range for the buckets from a newagde
Shimless would also be best as this engine is going to see some antilag/launch control
Thanks
Last edited by Denmark; 05 June 2015 at 05:17 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Car Parts For Sale
1
18 November 2015 07:49 AM