fitting those side repeaters/reflectors
#1
Is it just a case of get a small screw driverr under them(carefully) and pop in / pop out
Ive just bought the clear side repeaters and reflectors for my MY01 WRX - so is it pretty easy job?
cheers
andy
Ive just bought the clear side repeaters and reflectors for my MY01 WRX - so is it pretty easy job?
cheers
andy
#2
ADP,
If it's the same as a MY99 / 00 then you don't even need a screw driver. Catch hold of the lens the end closer to the front of the car and gently pull. They simply pull out, not hard at all
Cheers Phill C
If it's the same as a MY99 / 00 then you don't even need a screw driver. Catch hold of the lens the end closer to the front of the car and gently pull. They simply pull out, not hard at all
Cheers Phill C
#4
ADP,
Very very easy. It's not the same as MY99/00 ones though. If you're looking at the drivers side (for arguments sake) then get your fingers underneath the bottom edge of the reflector, if you pull up and back in line with the angle the reflector makes. This should relase the lip at the bottom which you can now pull away from the car and release the top forwards.
There is a metal spring type thing at the top which pushes the tab into place at the bottom.
Hope that this makes sense. If you want to wait and turn up to the Surrey meet (near Guildford on Sun 9th) I'll do it for you, in return for beer (only kidding, it's far too easy)
Cheers,
Simon
Edited to say, don't use a screwdriver. You will scratch the paint and regret it
[Edited by Scaramanga - 6/6/2002 5:35:43 PM]
Very very easy. It's not the same as MY99/00 ones though. If you're looking at the drivers side (for arguments sake) then get your fingers underneath the bottom edge of the reflector, if you pull up and back in line with the angle the reflector makes. This should relase the lip at the bottom which you can now pull away from the car and release the top forwards.
There is a metal spring type thing at the top which pushes the tab into place at the bottom.
Hope that this makes sense. If you want to wait and turn up to the Surrey meet (near Guildford on Sun 9th) I'll do it for you, in return for beer (only kidding, it's far too easy)
Cheers,
Simon
Edited to say, don't use a screwdriver. You will scratch the paint and regret it
[Edited by Scaramanga - 6/6/2002 5:35:43 PM]
#5
erp sorry no beer, it was as you said really quite easy
but a bloody RIP OFF, jees subaru I spend enuff in petrol without needing to spend 45 quid on plastic reflectors for vanity
but a bloody RIP OFF, jees subaru I spend enuff in petrol without needing to spend 45 quid on plastic reflectors for vanity
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM