Hawkeye Headlight Washers
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Mar 2015
Location: Edinburgh
Posts: 128
Likes: 0
Received 0 Likes
on
0 Posts
Hawkeye Headlight Washers
Does anyone know if the angle that these come out on can be adjusted?
When my drivers side one is closed there is a slight gap visible between the washer cover and the hole in the bumper
Thanks
Ade
When my drivers side one is closed there is a slight gap visible between the washer cover and the hole in the bumper
Thanks
Ade
#2
Scooby Regular
iTrader: (11)
Join Date: Feb 2011
Location: Newcastle upon tyne
Posts: 2,750
Likes: 0
Received 0 Likes
on
0 Posts
They are on a fixed bracket so I doubt it , however the tops are attached by 2 screws.
Possibly mis aligned or loose . It's just a suction push that forces them upwards , so if you ( gently get a flat knife under ) then pull it upwards you will be able to see if the top is slack . If so you need a very small Phillips to tighten . Other wise it's bumper off , as I suspect the washer stork bracket tab has snapped or cracked ... Hope this gives some clarity
Possibly mis aligned or loose . It's just a suction push that forces them upwards , so if you ( gently get a flat knife under ) then pull it upwards you will be able to see if the top is slack . If so you need a very small Phillips to tighten . Other wise it's bumper off , as I suspect the washer stork bracket tab has snapped or cracked ... Hope this gives some clarity
#4
Scooby Regular
iTrader: (11)
Join Date: Feb 2011
Location: Newcastle upon tyne
Posts: 2,750
Likes: 0
Received 0 Likes
on
0 Posts
I gather he just needs the top cover ^
I took my whole system off after the (Asda ) incident .
There in the garage boxed up somewhere 02c
1 top has a chip in it ( not sure wich at hand
If you wish me to look for you no probs
I took my whole system off after the (Asda ) incident .
There in the garage boxed up somewhere 02c
1 top has a chip in it ( not sure wich at hand
If you wish me to look for you no probs
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM