Lambda / O2 Sensor Help
#1
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Sep 2013
Location: Hoddesdon, Hertfordshire
Posts: 1,174
Likes: 0
Received 1 Like
on
1 Post
Lambda / O2 Sensor Help
Hi All,
Had a CEL on my Bug WRX... P0031 HO2S Heater Control Circuit Low (Bank 1 Sensor 1) so I checked it out and yup one of the wires on my sensor was basically snapped off so I replaced the sensor, however I am still getting the code. I suspect the fuse or relay has blown where the bare wire has shorted to the chassis, anyone any idea where the fuse is that needs replacing?
Had a CEL on my Bug WRX... P0031 HO2S Heater Control Circuit Low (Bank 1 Sensor 1) so I checked it out and yup one of the wires on my sensor was basically snapped off so I replaced the sensor, however I am still getting the code. I suspect the fuse or relay has blown where the bare wire has shorted to the chassis, anyone any idea where the fuse is that needs replacing?
#2
Scooby Regular
iTrader: (7)
Join Date: Mar 2013
Location: Belfast
Posts: 2,999
Likes: 0
Received 0 Likes
on
0 Posts
Apparently the fuses are in the passenger side behind the dash. You have to lay down on the floor looking upwards from the foot well and you should see them. 15amp from what I read.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM