Does anybody recognise these headers? They are a 4 into 2 into 1 unequal length set up, I have looked at loads on the internet and they are all 4 into 1's. Looking at the quality of the welding and the slip joints are double skinned it does not look like a cheap ebay job. The primaries are 40mm the secondaries are 43mm and the single peice is 47mm into the turbo.

I hope somebody can help as I would be interested to know who they are made by.

 

they look like syms.

 

Hi thanks for your help i have had a look on tinternet and they are definitely sysms racing headers, i was very surprised to see how much they cost new! they need a bit of a clean up and a small welding repair on a bracket that has cracked then im going to treat them to some dei heat wrap.

Thanks Again

 

no problem.