help. eml light after filter change
#1
Scooby Regular
Thread Starter
Join Date: Nov 2009
Location: Rugby
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
help. eml light after filter change
Ok so I've had a look on the forums can't find what I'm after....put an aftermarket filter on my blob eye wrx and the engine light is on... I was careful with maf...I have 2 mags to tryboth doing same...tried unplugging battery for 15 mins but didn't fix it... Was rough idle when first done but after a drive it's perfectly fine to drive now... Just Eml still on.. ideas?
#4
Scooby Regular
Join Date: May 2013
Location: welling,kent
Posts: 1,103
Likes: 0
Received 0 Likes
on
0 Posts
If you had unplugged maf then light would show on dash untill it was either reset with scan tool possibly by disconnecting battery for a while. On some cars if the fault hasn't reappeared within X amount of starts then ecu wipes the codes. I think my A-class merc was something like 50 starts before it reset the traction contol light each time it came on..
#5
Scooby Regular
Thread Starter
Join Date: Nov 2009
Location: Rugby
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
I went for a drive it seemed to sort the idle issue out.. think it was recalculating values maybe.. then next time i started it, it was fine
Its an Apexi Filter
Its an Apexi Filter
#6
Scooby Regular
Join Date: May 2013
Location: welling,kent
Posts: 1,103
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM
oilman
Trader Announcements
15
01 October 2015 11:55 AM