Mattybr5@MB Developments

iTrader: (250)

we have in a early wrx for breaking for genral spares no real mods on this car but it does have a rare cdb fitted along with a nice atferburner vortex exhust system aswell as some newage wrx 17inch alloys also

all parts are priced excluding postage but we can arrange postage at extra cost please ask


collection welcome from

pole postion uk
south street
willenhall
wv13 3tg

call or tx for quick reply 07785942237


ENGINE AND GEARBOX
tdo5 top entry turbo excellent working order pulls like a train no smoke or play etc complete atcutor and correct oil feed bolt also £90

slanty type tmic in good con complete with pipe work all in good con no tears or holes in pipe work getting hard to get now undamaged £30

phase 1 complete inlet with tb/ideal control valve all wiring and fuel rails etc £40


std map sensor good working order £15

green label maf excellent working order £30

std air box with std filter £20

airbox pipe work after maf to turbo £15

3 port boost solinoid excellent working order great upgrade for 2 ports complete with both ends of the wiring clip for easy fit £35

slim line jdm washer bottle with washer jet £15


2pin alternator good working order £20

start morot good workingt order £20

early pas pump good working irder no leaks or whines etc £25

rear drive shafts good con £25each

none abs hubs all good con good bearings £25each


EXTERIOR
front screen good con no chips or cracks £40

rear screen with wiper hole good con no cracks etc £40

prefacelift alloy lightweight bonnet good con complete with vents £30

prefacelift bumper in silver good con un cut etc complete with idercators £15

rear prefacelift bumper good con with unpainted hockey stick £15

rear bumper spats genuin subaru parts unpainted £30 pair

unpainted side skirts good con £30 set


prefacelift headlights good con £20pair

std fog lights good con £20pair

prefacelift grill good con £15

side lights good con £10pair

gutter trims £20pair

screen trims front and rear good con £10each


INTERIOR


prefacelift red grey turbo bucket seats good con no holes but some wear to the bolster foam on drivers side easy fix tho front and rear seats with matching prefacelift door cards £40set

carpet good con no rips etc £25




WHEELS/BRAKES
rear 1 pot rear brakes good working order with good used disk and pads £30set


all pics to follow

Tredy

Pmd

Mattybr5@MB Developments

iTrader: (250)

replied

Mattybr5@MB Developments

iTrader: (250)

PM'S REPLIED

nosjunkie

iTrader: (7)

what colour is it matt im looking for a nice cheap black boot lid

Mattybr5@MB Developments

iTrader: (250)

sorry bro its royal silver no black boots at the mo ether

all pm's replied

nosjunkie

iTrader: (7)

i read it in the tile after i posted lol

my cars silver as you know but i want black might just wrap it

Mattybr5@MB Developments

iTrader: (250)

just wrap it mush nice and easy to put back to standard then if you change your mind

all pm's replied

Mattybr5@MB Developments

iTrader: (250)

pm's replied

Ballyscoob

iTrader: (3)

would u send a door? what is paintn code?

Mattybr5@MB Developments

iTrader: (250)

sorry mate we have scrapped the doors today with the shell there was no interest in time sorry mate

all pm's replied

noblechris

iTrader: (1)

pic of wheels? cheers

Scoobyno1

iTrader: (22)

Hi mate, any chance you could show some pics of the afterburner exhaust and does the price include the centre pipe?

What would the price be including p&p?

Cheers.

Mattybr5@MB Developments

iTrader: (250)

chris sorry mate the wheels went over the week end mate sorry

scoobyno1 the afterburner is back box and center section mate we have put it on ebay it ends in a few hours so you could get a bargain pics are also on there mate here the link

http://www.ebay.co.uk/itm/2208534693...84.m1555.l2649

Scoobyno1

iTrader: (22)

Ok mate, would this exhaust fit a newage bugeye or is it for the classic?

Cheers.

Mattybr5@MB Developments

iTrader: (250)

you would have to run a classic down pipe to for it to fit as there slightly differnt lenghts if you use a classic decat or sumit its a straight fit mate or we could swao the center section over to a newage 1 we have in stack same none resonated 2.5inch straught thrue then it will fit with your down pipe for that bolt on jobby

Scoobyno1

iTrader: (22)

Yeah, i see what you mean mate, thanks. I do have a 2002 bugeye so would need the newage centre section. If i buy it on ebay i'll pm you on here to let you know.

Thanks

Mattybr5@MB Developments

iTrader: (250)

ok mate let us know so we know what center section to send if you did mate cheers

Scoobyno1

iTrader: (22)

Hi mate,

Sorry to be a pain but the newage centre section would fit straight up to the standard cat section before the manifold?

Plus looking at the pics, there looks as if there is some rust around the hanger on the actual silencer. What is that like or does the picture make it look worse?

Thanks

Mattybr5@MB Developments

iTrader: (250)

its stainless steel it carnt rust mate its just the pic as i didnt get chance to clean it the middle section joins to std down pipe your exhuast manifold joints to the turbo then from the turbo to the down pipe then to the center section so yes its a direct fit for yours with that newage center section bud

Scoobyno1

iTrader: (22)

Thanks for the info mate, i did forget to mention i dont have a turbo its an N/A, would this make a difference? So i basically have manifold to cat section to middle section to backbox, would this be right? I currently have a straight through pipe on from manifold to back box, with no joins and i need to put the cat back on for the MOT, but as it has no actual removeble decat pipe, i need to change to a cat back system so i can add the cat again. Its a bit long winded but have no scooby friendly garages near me.

Sorry for all the questions, but i'm new to subarus

Mattybr5@MB Developments

iTrader: (250)

hi bud you should have mentioned its not a turbo exhuast there is a 50/50 chance it fitting to your car now as a direct fit it might mate up to the decat you have then bolt straight on but there is that many differnt decats etc i really couldnt tell you for sure i wish you had said to start with mate its just gonna have to be try and see bud

all pm's replied exhuast now sold

Scoobyno1

iTrader: (22)

No that's alright mate ill try it and it should fit as I'm mating it up with a cat not a decat pipe so if its a proper cat back system then it should fit. If it don't then I'll have to change the centre section, so no probs.

Cheers

sp00ks

iTrader: (11)

Hey matt,

What's the best price you can do cash on collection (I bought some cams of kirstybumx3) so know how to get too you ;/)

Cheers

Mattybr5@MB Developments

iTrader: (250)

hi bud sorry i dont know what you want the best price on bud pm me if needed??

sp00ks

iTrader: (11)

Sorry mate lol bloody phone, best price cash for CDB ;-)

I seen it on bay for 400...

Cheers

Mattybr5@MB Developments

iTrader: (250)

yes it was for sale starting bid of 400 mate we would take 400 thats the lowist we been offered 380 for the block aloan just more hassle to strip it down to ship it so we happy to hang on for the right offer for the short motor complete mate

Mattybr5@MB Developments

iTrader: (250)

pm's replied cdb reduced to 300quid come grab BARGAIN

Mattybr5@MB Developments

iTrader: (250)

pm's replied

quattroowner

iTrader: (5)

cdb still avaiable?