Car stalling at low revs after map.
#1
Car stalling at low revs after map.
I got the car mapped last Thursday and it has started stalling at low revs like when slowing down and coming out of 2nd on the way down the gears it's cuts out which is really annoying and quite dangerous as I lose power steering. It was fine before the map I'm just not sure if it's the map or that it's just highlighting a problem that was already there. I have had it into the garage and they have messed around withe the idle and it's helped a little bit but it's still doing it.
It's like when I'm coming down the gears and out of second the Rev counter drops right down to zero then will jump back up, sometimes it catches it in time then other times it stalls.
Has anyone else had this issue before.
Also I have just had the front o2 sensor replaced but with no improvement.
It's like when I'm coming down the gears and out of second the Rev counter drops right down to zero then will jump back up, sometimes it catches it in time then other times it stalls.
Has anyone else had this issue before.
Also I have just had the front o2 sensor replaced but with no improvement.
#4
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
agree the idle valve can do this if its a newage imparticular but if it was okay before remap and not after then possibly not..
need more info on mods and year of car
need more info on mods and year of car
#5
It's a 03 wrx, td05 20g 550cc Injectors sti tmic sytec fuel pressure regulator tubular manifold and up pipe and from turbo back exhaust.
Idle control valve was mentioned today thinking it might be a sticking sensor.
Idle control valve was mentioned today thinking it might be a sticking sensor.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM